Satellite Receivers Software Downloads

Sat Finder loader, How to use loader on satellite finder?

Hello, viewers today I’m going to Share With You that how you can recover your satellite finder through the loader. but before I share the loader tool you need to know about the sat finder loader tool.

What’s a loader and how to use it?

Sometimes During Software upgrades or downgrades due to wrong Software or any other mistake our Satellite Finder goes dead or stuck on a red light. So in that case we have two ways to recover our satellite Finder. We can recover our box with a loader tool, and the second option we have is the Bios flashing Programmer which is available mostly with mechanics. But in that post, I’ll discuss the loader tool.

Loader tool is a computer Software, which every Satellite Receiver manufacturer is providing to their users for use during any damage or losses. For the Recovery of our Receiver, we need three 3 basic things. (1) Computer. (2) RS232 Cable and (3) Loader tool.
May you know about computer or laptop so I don’t need to discuss further the computer.

What’s RS232 Cable?

For the injection of software to our Sat finder, we need three main Connections RX, TX, And GND from our Satellite Finder to Computer or loader. So for that, We need to connect Sat finder to our Computer or laptop. in that case, we need a specific Cable, which is called Rs232 or db9 cable. You can purchase Rs232 Cable in any local electronic market or from any Satellite dish mechanic Shop, even you can also buy from any online store.

Rs232 Cable for laptop User.

If you have a laptop user and you want to use all that process on the laptop then you need to buy two cables one is the Rs232 to Micro USB male Cable, and the second one is Rs232 female to USB cable. These two cables are not very much expensive. And you can buy very easily from any Electronic market or online store. But be noted we need to inject the Software to any Satellite Finder through Ch341 or Ch340 IC, so when you buy the Rs232 USB cable, you have to demand from the shopkeeper to give you the Rs232 USB cable with Ch340 or Ch341 Supported IC. Otherwise, the Loader will not Work.

sat finder loader

 

Rs232 Cable for PC/Computer Users.

If you have a PC or Computer and you want to use the loader on that. Then you have to need to buy one simple cable RS232 to Micro USB Cable. And you can do all the process with that Single Cable.

sat finder loader

Sat Finder loader.

When you have arranged all the above things as per your requirement, after that you need to loader tool regarding your satellite finder processor. There’s multiple Satellite finder manufacturer with different Processor. But in that post, I’m going to share with you the Gx processor loader. You can use the following loader for the Gx Processor Supported Sat Finder.

How To Use loader for Sat finder.

when you arrange the above equipment, now it is time to connect your satellite finder with your computer or laptop. if you are using a laptop then you have to insert the micro USB port to your Sat Finder and insert the male connector to the RS232 Female to USB cable. if you are using a PC then you have to insert the micro USB port to your sat finder and the USB port side to your computer. see in below picture.

 How to use loader on satellite finder

after doing the above process, now open the loader, which download link I am going to share below, and follow the step as I mentioned in the pictures.

Sat Finder loader

sat finder loader

Gx loader for Gx Supported Sat Finder.

Download

Get real time updates directly on you device, subscribe now.

Leave A Reply

Your email address will not be published.

This website uses cookies to improve your experience. We'll assume you're ok with this, but you can opt-out if you wish. Accept Read More